Grand Motors banner
Auto otpad Sole banner Led Shop banner
Knežević Enterijer banner Faber auto delovi banner

Zatezivanje bregaste i glave focus 1.6 16v

Odeljak za mehaničke kvarove.
Pravila foruma
Svako pitanje koje traži rešenje problema, a koje ne sadrži u naslovu teme: model auta, godinu proizvodnje,tip ubrizgavanja, zapreminu i snagu motora, biće obrisano bez opomene. U poruci napisati kratak i sažet problem.

Moderator: Dragomir

Odgovori
nenad995
Poruka: 35
Član foruma od: četvrtak, 27. avg. 2015. u 18:28h

Zatezivanje bregaste i glave focus 1.6 16v

Poruka od nenad995 » utorak, 3. sep. 2019. u 14:06h

Drugari treba mi pomoć. Zanima me na koliko "kila" se stežu šrafovi (ležajeva) bregaste i na koliko se steže glava motora?
U pitanju je ford focus 1.6 16v zetec se 2003-e godište

Poslato sa WAS-LX1 pomoću Tapatoka

Nenad :ford:

Avatar korisnika
mbole
Poruka: 14393
Član foruma od: ponedeljak, 6. jun 2011. u 23:09h
Lokacija: Bataja

Re: Zatezivanje bregaste i glave focus 1.6 16v

Poruka od mbole » utorak, 3. sep. 2019. u 14:22h

Bregasta

µ 3. CAUTION:
Lay the camshaft in place so that none of the cams is at full lift.
Note:
The camshaft bearing cap numbering starts at the timing belt end with E1 on the exhaust side and with I1 on the inlet side.
Note:
The exhaust camshaft has an additional cam for the camshaft position (CMP) sensor.
Install the camshafts and camshaft bearing caps.
l Lubricate the camshafts and camshaft bearings with engine oil before installation.

µ 4. Note:
Tightening sequence.
Fit the camshaft bearing cap and tighten the bolts in three stages.
l 1st Stage: One half turn on each bolt until the camshaft bearing cap meets the cylinder head.
l 2nd stage: 7 Nm
l 3rd stage: 45 degrees


redosled:

Slika

Glava
µ 1. Note:
Tightening sequence.
Note:
The cylinder head is placed into two guide sleeves.
Note:
The cylinder head bolts can be re-used.

Attach the cylinder head.
l Make sure all mating faces are clean.
l Fit a new cylinder head gasket.
l Install the cylinder head, tightening in four stages in the sequence indicated.
l Stage 1: 15 Nm.
l Stage 2: 30 Nm.
l Stage 3 using Special Tool 303-174: 90 degrees.

redosled

Slika
Mondeo, Mk2, 1998, 1.8TD, Ghia, naftarica je naravno karavan

Odgovori

Povratak na „Kvarovi i popravke“